Spin cast feeders are used primarily to attract deer to your feeder. Spin feeders toss out deer corn or AntlerMax WaterShield Deer Chow pellets at timed intervals.
Place your feeders along frequently used runways or trails and be sure to have enough so that they do not have to travel more than ½ to ¾ of a mile to a feeder. A good rule of thumb is to provide one feeder per 300-400 acres. Never hunt in a feeding area.
For best results, make sure your feeder location provides:
- An easy approach into the wind
- Good visibility
- Access to fresh clear water
- Easy escape routes near cover
- Good deer traffic
To help keep deer on your low or unfenced property, place your feeding areas near the center of your land and no closer than 500 feet from the perimeter. Do not place feeders along fence lines, roads, power lines or in large openings.
If you have hogs in the area make sure to have a hog fence barrier around your feeder, no less than 50′ in diameter.
Russell Feed & Supply stores are located throughout the greater Ft. Worth area and carry Triple C Feeders. Triple C Feeders can be programmed to feed up to 6 times per day. Options include varmint guards and solar panels. Available in 6v and 12v packages. Triple C Feeders are built in the USA. Talk to us today about a Triple C Feeder.
Share this page
- Saturday, April 4:
- Sunday, April 5:
- Saturday, April 11:
- Sunday, April 26:
- Saturday, May 2:
- Sunday, May 3:
- Saturday, May 9:
- Sunday, May 24: